□ A research team led by Dae-Kue Hwang and Dae-Hwan Kim of the Division of Energy & Environmental Technology at DGIST (President Kunwoo Lee) has developed a high-efficiency bifacial antimony-based (Sb₂(S,Se)₃) thin-film solar cell equipped with a transparent polymer rear electrode. The device converts light entering from both the front and rear sides into electricity.
□ To increase the amount of electricity generated by solar cells, it is essential to develop technologies that capture and harness not only direct sunlight but also light reflected and scattered by the ground and surrounding objects. In this regard, two approaches have attracted considerable attention as next-generation solar cell technologies: bifacial structures, which absorb light from both the front and rear sides, and tandem structures, which enhance efficiency by stacking two solar cells that absorb different wavelengths of light. However, a major challenge in realizing efficient bifacial power generation has been the development of a high-performance, highly transparent rear electrode that allows light to pass through while efficiently collecting electrical current.
□ The research team addressed this challenge by developing a high-performance transparent rear electrode structure comprising multiple layers of specialized transparent conductive polymers deposited through a solution-based process. In particular, the team added a specific additive (DMSO) to the conductive polymer to precisely control its electrical conductivity. This approach reduced electrical resistance, which impedes the flow of current, by a factor of 10,000 (four orders of magnitude) while maintaining high optical transparency.
□ The resulting bifacial antimony-based solar cell achieved power conversion efficiencies of 8.2% under front-side illumination and 3.3% under rear-side illumination. Furthermore, the research team successfully demonstrated a four-terminal tandem structure by placing the antimony-based solar cell on top as the upper cell and combining it with a CuInSe₂ solar cell as the lower cell. The two cells absorb light at relatively different wavelengths.
□ By combining the strengths of both solar cells, the tandem device achieved a power conversion efficiency of up to 12.32%. Notably, when both the front and rear sides were illuminated simultaneously at an intensity of 1 sun each, the tandem device achieved a bifacial power density of 18.81 mW/cm². This result demonstrates the device’s ability to convert even scattered light reflected from its surroundings into electricity without waste.
□ “This study has conclusively demonstrated not only the feasibility of bifacial power generation using antimony-based solar cells but also their potential for integration into tandem solar cells through the newly developed transparent polymer rear electrode,” stated the research team led by Dae-Kue Hwang and Dae-Hwan Kim of DGIST’s Division of Energy & Environmental Technology. “We plan to further improve solar cell performance by optimizing the interface between the electrode and the light-absorbing layer, as well as the optical structure.”
□ This research was supported by the DGIST R&D Program, the InnoCORE Program of the Ministry of Science and ICT (MSIT), the National Research Foundation of Korea (NRF), and the Korea Institute for Advancement of Technology (KIAT). The findings were published in Advanced Materials, a leading international journal in energy and materials science.
Published: 16 Nov 2026
333, Techno jungang-daero, Hyeonpung-myeon, Dalseong-gun, Daegu, 42988
Bringing discovery to light