Co-Sensitizing Solar Cells With Berry and Sandalwood Extracts Boosts Efficiency – Bioengineer.org

Co-Sensitizing Solar Cells With Berry and Sandalwood Extracts Boosts Efficiency
Co-sensitizing quasi-solid-state dye-sensitized solar cells with crude natural extracts from Sea buckthorn berries and Red sandalwood yields improved photovoltaic performance compared with mono-sensitized cells. In an experimental investigation published in Materials for Renewable and Sustainable Energy, an optimized photoanode incorporating twenty-five percent Sea buckthorn berry extract and seventy-five percent Red sandalwood extract achieved a power conversion efficiency of 1.20 percent under standardized sensitization conditions, surpassing cells sensitized with either plant extract alone.
The investigated devices belong to the class of quasi-solid-state dye-sensitized solar cells, which utilize a polymer-in-salt electrolyte alongside titanium dioxide photoanodes. In these systems, co-sensitization serves as a strategic method to broaden solar light absorption, enhance electron injection into the semiconductor, and suppress undesirable charge recombination processes. To examine whether natural dye combinations can achieve these benefits, the authors evaluated extract solutions derived from Sea buckthorn berries, abbreviated as SBT, and Red sandalwood, abbreviated as RSW, both individually as mono-sensitizers and together as co-sensitizers.
To understand the properties of the sensitized titanium dioxide photoanodes, the research team conducted comprehensive material and optical characterizations. They utilized X-ray diffraction to assess the structural crystallinity of the photoanode material and Fourier-transform infrared spectroscopy to verify the presence of chemical functional groups. Additionally, the researchers performed field emission scanning electron microscopy to analyze surface morphology and used ultraviolet-visible spectroscopy to evaluate optical absorption characteristics, providing a detailed material baseline for comparing single-dye and blended-dye formulations.
Photovoltaic testing revealed that the ratio of the two plant dyes significantly influences device performance. The optimized co-sensitized formulation containing twenty-five percent Sea buckthorn extract and seventy-five percent Red sandalwood extract generated a short-circuit current density of 5.00 milliamperes per square centimeter, an open-circuit voltage of 447 millivolts, and a fill factor of 0.51. Together, these current density–voltage metrics produced the top power conversion efficiency of 1.20 percent recorded in the study.
This performance represented a clear gain over the corresponding mono-sensitized solar cells tested under identical experimental conditions. Devices sensitized solely with Sea buckthorn berry extract attained a power conversion efficiency of only 0.46 percent, while devices sensitized exclusively with Red sandalwood extract reached 0.93 percent efficiency. According to the researchers, the superior photovoltaic response observed in the twenty-five to seventy-five berry-to-sandalwood blend is consistent with the complementary optical characteristics of the two natural sensitizers and their possible combined contribution to light harvesting and photovoltaic conversion.
Lumped electrical parameters derived from current density–voltage curves provided further insight into the performance differences across the tested cells. The optimized twenty-five to seventy-five co-sensitized device exhibited the lowest apparent series resistance at 163.3 ohms and the highest apparent shunt resistance at 10,591 ohms among all tested configurations. By comparison, the mono-sensitized Sea buckthorn device displayed an apparent series resistance of 413.8 ohms, whereas the mono-sensitized Red sandalwood device registered 199.7 ohms. The authors emphasized that these lumped parameters serve as supporting electrical characteristics of the fabricated cells rather than direct measurements of interfacial charge-transfer resistance or internal recombination kinetics.
To confirm the reliability of these measurements, the authors applied rigorous statistical validation across five independently tested devices per experimental condition. Data were evaluated as the mean plus or minus standard deviation, accompanied by analysis of variance and Tukey’s honestly significant difference post hoc analysis. The variations observed across short-circuit current density, open-circuit voltage, fill factor, efficiency, series resistance, and shunt resistance remained relatively small, staying within approximately five to ten percent for most parameters and demonstrating solid reproducibility among the fabricated quasi-solid-state cells.
The findings underscore the technological viability of using crude plant-derived co-sensitizers to build environmentally compatible, eco-friendly dye-sensitized solar cells. While the study confirms performance gains from the berry and sandalwood combination, the authors explicitly outlined the analytical boundaries of the current work. They noted that the present findings provide a foundational basis for deeper mechanistic studies, recommending future investigations that incorporate electrochemical impedance spectroscopy, incident photon-to-current efficiency measurements, and quantitative dye-loading evaluations conducted on freshly fabricated devices.
Subject of Research: Co-sensitization of quasi-solid-state dye-sensitized solar cells using plant extracts
Article Title: Synergistic enhancement of quasi-solid-state dye-sensitized solar cells using carotenoids and santalin as co-sensitizers
Article References: Chaudhari, N., Walake, S., Jadhav, Y., Sonawane, C., & Kulkarni, A. (2026). Synergistic enhancement of quasi-solid-state dye-sensitized solar cells using carotenoids and santalin as co-sensitizers. Materials for Renewable and Sustainable Energy. https://doi.org/10.1007/s40243-026-00410-5
Image Credits: AI Generated
DOI: 10.1007/s40243-026-00410-5
Keywords: dye-sensitized solar cells, quasi-solid-state electrolytes, co-sensitization, sea buckthorn berries, red sandalwood, polymer-in-salt electrolyte, titanium dioxide photoanodes, power conversion efficiency, short-circuit current density, open-circuit voltage, fill factor, series resistance, shunt resistance, optical absorption, X-ray diffraction, Fourier-transform infrared spectroscopy, field emission scanning electron microscopy
News Source: Denise Maddox. (November 16, 2026). Co-Sensitizing Solar Cells With Berry and Sandalwood Extracts Boosts Efficiency. Scienmag.
We bring you the latest biotechnology news from best research centers and universities around the world. Check our website.
Enter your email address to subscribe to this blog and receive notifications of new posts by email.


Bioengineer.org © Copyright 2023 All Rights Reserved.
Login to your account below




Please enter your username or email address to reset your password.


Bioengineer.org © Copyright 2023 All Rights Reserved.

source

This entry was posted in Renewables. Bookmark the permalink.

Leave a Reply