UNSW tests aluminium, copper and nickel to cut silver use in solar cells – OwnedCore

Researchers at UNSW Sydney are developing ways to cut the amount of silver used in solar cells, as the cost and limited supply of the precious metal weigh on photovoltaic manufacturers worldwide.
A team led by Dr Ning Song, a senior lecturer in UNSW’s School of Photovoltaic and Renewable Energy Engineering, is working with Scientia Professor Martin Green to test cheaper metals for the electrical contacts that collect current from a cell. The university outlined the work on 16 November.
Silver is the standard material for solar cell contacts because it conducts electricity well and is easy to screen-print onto the cell surface. Industry analysts estimate that silver paste accounted for as much as 30 per cent of cell manufacturing costs when silver prices peaked in early 2026, although the share varies with cell design and the amount of paste used.
Supply is also a concern. Silver is a finite resource, and UNSW’s Australian Centre for Advanced Photovoltaics (ACAP) has estimated that PV manufacturing consumed roughly a quarter of global silver supply in 2025.
The team is examining several alternatives. Aluminium is cheaper but less conductive, and the researchers have been adjusting paste composition and firing conditions to compensate. In industrial TOPCon cells, aluminium rear contacts reached an efficiency of 22.9 per cent, compared with 23.7 per cent for reference cells using silver contacts.
Copper and silver-coated copper offer strong conductivity at low cost, but copper oxidises and can migrate into the silicon, degrading the cell.
In work published in the journal Solar Energy Materials and Solar Cells, the group replaced 10 per cent of the silver powder in the rear contacts of industrial TOPCon cells with nickel. The change cut raw metal costs by 6.8 per cent for an efficiency loss of only 0.024 percentage points, although higher nickel content increased paste consumption and offset the savings.
Dr Song said the best replacement depends heavily on the cell structure, and that manufacturers would need confidence from outdoor testing before adopting new contact materials in panels expected to last 25 to 30 years. Song said silver-free contacts could appear in selected cell technologies over the coming years.
Separately, an ACAP team led by Associate Professor Brett Hallam has developed a silver-lean screen-printing approach, supported by the Australian Renewable Energy Agency, that confines silver to tiny dashes at the silicon interface and uses copper or aluminium pastes for the bulk of the conductor.
Back to homepage

source

This entry was posted in Renewables. Bookmark the permalink.

Leave a Reply